Plasma Shop Logo
 
CNC Plasma Shopping Catagories

MACAIR HX10A CNC Plasma Cutting Compressed Air Dryer

Air Dryer For CNC Plasma Cutting
$ 799.00(USD)

FREE Shipping
in Continental USA
& Canada

Fast, Secure Payment With

Fast, Secure Payment With PayPal
  • - Made in the USA
  • - 3 in 1 Aluminum Heat Exchanger
  • - Tecumseh and Copeland refrigerant compressors
  • - Sporlan and Alco controls
  • - ON/OFF Switch
  • - Electronic Drain
  • - 6 Foot Power Cord & Plug
  • - Aircooled Condenser with Fan Motor
  • - Fan Cycling Control
  • - Hot Gas Bypass Valves
  • - High Pressure Shutdown switch w/manual re-set
  • - Refrigerant Access Ports
  • - Low Pressure Drops
  • - Constant dew point of 38°F
  • - 10 cfm capacity perfect for air plasma cutters
  • - Dramatically increases plasma nozzle & electrode life
  • - Dramatically increases cut quality & edge finish
  • - Clean dry air provides a stable arc & improved THC operation
HX10A
Capacity, Dewpoint 10 SCFM @ 38°F Dewpoint | 14 SCFM @ 50°F Dewpoint
Refrigerant Comp, HP 1/6 Horsepower
Inlet / Outlet, FTP 3/8" Female pipe thread
Maximum Pressure 230 psi
Maximum Temp. 100ºF (38ºC) For maximum performance
Pressure Drop 2.5 psi - 5.0 psi average pressure drop
Input Power 115v 1ph 60Hz
Refrigerant Type Environmentally Friendly R134a
Dimensions 15"W x 13"D x 11"H
Shipping Weight 77 lbs

"I finally got my new MacAir dryer on line. I decided to re pipe my shop with a Rapid Air system to get rid of the trash in my air lines so it took me a little longer to get back on line. I cut a few test pieces to make sure everything was working with an old tip and it worked as advertised. I set up my new jobs and was going to change the tip and electrode and forgot. I cut about 3 hours Saturday and probably another 3 hours yesterday using the same old tip and electrode without any noticable difference in cut quality. That's probably about a 300% increase in consumable life so far. At this point I have to say that I'm very satisfied. The only problem I've had so far is the automatic drain scaring me half to death the first couple of times it went off."
PlasmaSpider Member: Woodville Iron