I dont really have a lot of pictures that are not on my phone, but I will share this short video I made on this sign I built a few weeks ago. I really wish there was an android app for plasmaspider so I could upload pictures easier from the phone.
http://youtu.be/wpS6JT3SXKc?list=UUS9-g ... XaDqVQLTFw
Commissioned Sign
-
weldor2005
- 3 Star Member
- Posts: 353
- Joined: Fri Mar 01, 2013 4:22 pm
- Location: Southern Kansas City Area
- Contact:
Commissioned Sign
David Finch CWI
Plenty of welders
Plasmacam 4x4 with DHC2
PowerMax 45
Lots of other toys
Plenty of welders
Plasmacam 4x4 with DHC2
PowerMax 45
Lots of other toys
-
SeanP
- 4 Star Member
- Posts: 950
- Joined: Thu Aug 01, 2013 11:50 am
- Location: Co Kerry, Ireland
Re: Commissioned Sign
Nice job David, wow those cut looked nice and square, wish I could get mine as good.
Powermax XP45
Home built table, Candcnc DTHC 2, Dragoncut 620-4
R-Tech 210 Tig, Jasic 250 mig
Sheetcam, Scanything, Coreldraw
Table build gallery
Home built table, Candcnc DTHC 2, Dragoncut 620-4
R-Tech 210 Tig, Jasic 250 mig
Sheetcam, Scanything, Coreldraw
Table build gallery
-
weldor2005
- 3 Star Member
- Posts: 353
- Joined: Fri Mar 01, 2013 4:22 pm
- Location: Southern Kansas City Area
- Contact:
Re: Commissioned Sign
Well, they are nice and square on top and angularity isn't bad for 3/8" plate. The cuts are rounded a bit on the bottom side though. My only concern was screwing up that expensive plate since for the life of me I can't seem to get my Height control working. This was evident in the extra hour of wire wheeling the dross off of everything.SeanP wrote:Nice job David, wow those cut looked nice and square, wish I could get mine as good.
David Finch CWI
Plenty of welders
Plasmacam 4x4 with DHC2
PowerMax 45
Lots of other toys
Plenty of welders
Plasmacam 4x4 with DHC2
PowerMax 45
Lots of other toys
