Pro Plas HP 105 height

Don't see your table manufacturer listed above? Post here in this forum.
Post Reply
SF Fab
1/2 Star Member
1/2 Star Member
Posts: 1
Joined: Tue Jul 18, 2017 7:23 pm

Pro Plas HP 105 height

Post by SF Fab »

Good Morning,

Just chasing some info on this product, we have a Pro Plas 1530 CNC cutting machine with an 85 Amp Hypertherm cutting system with a Starfire controller 2300, we are cutting a lot of perforated panels and need to change the height that the torch goes up and down to the next hole as these are only 7mm dia and there are 225 holes per plate in 1mm Zincanneal, at the moment it goes up about 60mm and then comes down to pierce and cut the next hole we want to change this to be about 10mm till it traversers to the next hole and this will cut out time down significantly.

There is nothing in the manual about this can anyone please help
Jawz
1/2 Star Member
1/2 Star Member
Posts: 3
Joined: Fri Jun 22, 2018 3:37 am

Re: HP 105 Heavth

Post by Jawz »

Hi Heavth,

I have also bought a Pro Plas recently. How do you like it. I am trying to find a better program than fastnest to use. What are you running
Dfabltd
1 Star Member
1 Star Member
Posts: 14
Joined: Sun Oct 27, 2019 2:47 am

Re: Pro Plas HP 105 height

Post by Dfabltd »

under plasma setting on the controller change torch time up to .25 and torch time down to the same value
Post Reply

Return to “Various Manufacturers Forum”