Hypertherm copper plus fine cut consumables

For general topics and questions that do not fit into any of the other categories or forums.
Post Reply
User avatar
little blue choo
4 Star Member
4 Star Member
Posts: 1460
Joined: Mon Mar 02, 2015 10:38 pm
Location: Cherryville NC
Contact:

Hypertherm copper plus fine cut consumables

Post by little blue choo »

I purchased some Hypertherm Copper Plus fine cut consumables and immediately noticed less dross. I get great life out of my regular fine cut consum. but though if I could get even better why not give them a try. I usually have very little dross and wasn't looking to reduce it but was surprised to see even less. (Very Noticeable Difference). Just wondering if anyone else has had this same experience. Maybe Jim can explain this one.

Rick
Rick
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape
jimcolt
5 Star Elite Contributing Member
5 Star Elite Contributing Member
Posts: 3087
Joined: Mon Jul 20, 2009 11:18 pm
Location: North Carolina

Re: Hypertherm copper plus fine cut consumables

Post by jimcolt »

They should cut the same as the standard electrodes, just will last considerably longer. Jim
plasmartist
2 Star Member
2 Star Member
Posts: 68
Joined: Mon Aug 07, 2017 1:31 pm

Re: Hypertherm copper plus fine cut consumables

Post by plasmartist »

What part numbers are your consumables? The majority of my work is finecut, but I wasn't aware that there were copper plus options... or are you just using the copper plus electrode?
Post Reply

Return to “CNC Plasma Cutters General Forum”