Deer in Scope

[kurtjohn]

Anyone able to make this into dxf??? Would like to cut it out for myself without the name on the bottom of it. Thanks in advance.

[harrymorley]

here are two similar files . never been cut . check for drops in the eyes and nose in the headshot. Adding landscape if wanted should be a snap.

deer in scope.dxf

[Colebakken]

Something close to this?

[Colebakken]

Clean file, Ready to cut Enjoy!

Colebakken_12_Inch_Deer.dxf

[kurtjohn]

Thank you very much

[Strawboss]

Thanks for the share

[inspectweld]

Very nice file, but it is blank when I try to open it with autocad 2002 edition

[adbuch]

Very nice file, but it is blank when I try to open it with autocad 2002 edition

Try importing instead of opening.
David

[inspectweld]

Very nice file, but it is blank when I try to open it with autocad 2002 edition

Try importing instead of opening.
David

It should open if saved to an earlier version and re posted, not sure what you mean about importing. The only importing I do is when I import a DXF file to my plasma cutting program. And that`s only after my autocad drawing is complete and ready to cut. Thanks for the help

[RSMetalworks]

thank you!

[inspectweld]

Thanks anyway, got it open with inkscape with help from Larry