Very nice, thanks for the share
Pat
Ivy Fairy
-
- 2 Star Member
- Posts: 68
- Joined: Tue Jan 28, 2014 3:20 am
- Location: South Africa
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7784
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Ivy Fairy
Hi Ben
I downloaded the ivy fairy you posted on plasma spider and want to thank you for that.
It looks just wonderful and I would like to make one. I have a question about the assembly I can only see one place where the 1/4" wire attaches to the fairy (at the wing). Where else did you weld attachments between the fairy and 1/4" vine or leaves?? Also how tall is the fairy I played with it in SheetCam and made it about 15" tall is that close??
Have fun
Tom
I downloaded the ivy fairy you posted on plasma spider and want to thank you for that.
It looks just wonderful and I would like to make one. I have a question about the assembly I can only see one place where the 1/4" wire attaches to the fairy (at the wing). Where else did you weld attachments between the fairy and 1/4" vine or leaves?? Also how tall is the fairy I played with it in SheetCam and made it about 15" tall is that close??
Have fun
Tom
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
-
- 1 Star Member
- Posts: 22
- Joined: Tue Dec 07, 2010 9:37 pm
- Location: Oregon
Re: Ivy Fairy
Thanks, nice file
-
- 1 Star Member
- Posts: 11
- Joined: Fri Aug 07, 2015 10:48 pm
Re: Ivy Fairy
Thanks for the share! Terrific!