Practical cnc

Don't see your table manufacturer listed above? Post here in this forum.
Post Reply
Patrick Waite
2.5 Star Member
2.5 Star Member
Posts: 239
Joined: Sun May 16, 2010 3:28 am

Practical cnc

Post by Patrick Waite »

Hey all its been awhile sense i have posted anything on this page. So im wondering if any of you are still useing a Practical cnc Machine. Well I have 5x10 foot table servo motors and been going through it as I had some trouble. Been go to do an upgrade on the table but the funds are low. So in talking about my problem. Im looking for is the configuration setting for my table. If someone could post them on here that would be great. The ones that i have are not right.

Thank you Patrick Waite
Patrick
Post Reply

Return to “Various Manufacturers Forum”