Problem with hypertherm hsd 130

Hypertherm Plasma Cutter discussion forum.
Post Reply
Walid2525
1/2 Star Member
1/2 Star Member
Posts: 1
Joined: Sun Apr 22, 2018 7:58 am

Problem with hypertherm hsd 130

Post by Walid2525 »

Hello
I have a problem with my hypertherm 130 . Specially when I use a 130 oxygen/air. And the error message code 20 appears. " Lose arc pilote". But when I create a leak in the oxygen plasma it works. Can anyone explain how to resolve this problem.
Thank you
sphurley
3 Star Elite Contributing Member
3 Star Elite Contributing Member
Posts: 445
Joined: Sat Jul 04, 2015 10:43 pm

Re: Problem with hypertherm hsd 130

Post by sphurley »

I would repost this up the the plasma cutter (Hypertherm) section for Jim Colt to reply.
Steve
Platform CNC Plasma table
CandCNC Ethercut IV DTHC
Hypertherm 85/CPC/RS485
Miller 350P
Miller Dynasty 280DX
METALWORX-IND
1 Star Member
1 Star Member
Posts: 23
Joined: Fri Dec 01, 2017 3:44 pm
Location: Nashville, Arkansas

Re: Problem with hypertherm hsd 130

Post by METALWORX-IND »

I have heard of people having similar problems in the past when the pressure was too high going into the auto gas control unit. Check and see what your pressure regulator on your oxygen is set at and try to adjust it down and see if that helps.
Post Reply

Return to “Hypertherm Plasma Cutters”