4th Gen Firebird Logo

[NWILL]

Can anyone help with this? My software doesn't have the capability to put an outline around this so I can cut it in one piece and my Inkscape program isn't acting right. I tried reinstalling it and haven't had any luck yet. Thanks!

[Larry83301]

Would this one work?

http://www.plasmaspider.com/viewtopic.p ... ird#p24929

It comes out as a single piece.


Larry

[Gamelord]

Hope this helps

firebird-new-logo.dxf

firebird-new-logo.svg

[NWILL]

That is exactly what I was trying to do. Thank you!!

[little blue choo]

Hey Gamelord, I just checked the SVG you posted and the bird in the middle will need to be tied in or it's going to drop out. No offence my friend, you are much better at this than me, just wanted to save someone some time and material.

Rick

[Gamelord]

I only did the outline. I never know if the person asking is doing vinyl or multi layered pieces. If they are not sure how to tie pieces in then I wonder why they have a plasma table and what they actually do with it.

[little blue choo]

10-4 I was assuming and you know what that does.

This proverb plays on the fact that the word "assume" may be broken down into the letters "ass", "u", and "me", and is intended to suggest that one should not make assumptions because they may turn out to be wrong and make those involved appear foolish

Will try to think before speaking next time. LOL

[plasmanewbie]

Thanks Gamelord for the conversion and outline, I have a friend who would love one these cut for his shop wall!

[mcagauto]

Thanks