Help with trace-1938 Chev Sedan

BAC42 · Post by **BAC42** » Sat Jan 02, 2016 1:19 pm

Hi Guys, HAPPY NEW YEARS.
A friend asked if I could make a cut of his new car, I've been playing with this for a week and getting no place. Anyone want to give it a shot?
Thanks

Optimized-309(1).jpeg

beefy · Post by **beefy** » Sat Jan 02, 2016 3:55 pm

Ben de Lappe does conversions for a good price. Small price to pay if you've been at it for a week.

By the way you are asking for conversion help in the wrong section of the forum. This is the DXF "sharing" section, and the moderator has made a section specifically for asking for conversion help.

Post by **kdahep** » Sat Jan 02, 2016 4:14 pm

Check out my posts kdahep
I drew one of these very similar maybe 3 years ago
Looks like 37 Chevy
If I knew how to import something into this topic I would
Go to Page 2 Last post on the page

38 Chevy 10 inch It is only a 2 door not a 4 door but should be able to draw the rear door and shorten the front door and be cut ready.

Let me know if this helps

1938 Chevrolet sedan 10 inch.dxf

Post by **Larry83301** » Sat Jan 02, 2016 4:43 pm

kdahep wrote:If I knew how to import something into this topic I would
Go to Page 2 Last post on the page

38 Chevy 10 inch It is only a 2 door not a 4 door but should be able to draw the rear door and shorten the front door and be cut ready.

Let me know if this helps
1938 Chevrolet sedan 10 inch.dxf

kdahep , Just go to the post you want to reference and right click on the subject line and copy short-cut, then paste it in your comment. It will look like this - - - http://www.plasmaspider.com/viewtopic.p ... 06#p109316 - - - in your post it gets shortened up to look like a link. Hope that helps you.

Larry

little blue choo · Post by **little blue choo** » Sat Jan 02, 2016 11:47 pm

10/4 on Ben de Lappe. I just had him do a photo for me and it came out awesome and the price was way more than fair. The Lady love it.

Rick

Post by **Hootville** » Mon Jan 04, 2016 2:00 am

Try this one. dxf overlay of the photo. I cleaned it up quite a bit, but will leave the rest to you as i'm not sure what cut detail you are looking for. you can drop your own photo in the background of the dxf file to obtain or remove any details. Hope it helps.....

BAC42 · Post by **BAC42** » Mon Jan 04, 2016 7:42 am

Hi Hootville, thanks for the trace, I cleaned up some area's I didn't want and will try and get it cut today.

Thanks, Bill

little blue choo · Post by **little blue choo** » Mon Jan 04, 2016 6:56 pm

Good looking trace Hootville

Rick

Help with trace-1938 Chev Sedan

Help with trace-1938 Chev Sedan

Re: Help with trace

Re: Help with trace

Re: Help with trace

Re: Help with trace

Re: Help with trace-1938 Chev Sedan

Re: Help with trace-1938 Chev Sedan

Re: Help with trace-1938 Chev Sedan