I am getting an error message when I load a G-code into Mach 3 that is bugging the heck out of me. This happens when I run a Plasma mode Mach 3 profile and I load any G-code in it will stop and give then message "Radius to end of arc differs from radius to start" and go no farther in the initial reading of the G-code. If I load another profile it will work just fine. It is not related to the G-code as I have tried many G-codes all work in on profile and none in the other. I am sure it is a setting in Mach.
Help would be appreciated
Error message question
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7818
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Error message question
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7818
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Error message question
I went to the Mach3 form and found the answer, change the IJ mode to Inc from Absolute works fine now
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
- ben de lappe
- 4 Star Elite Contributing Member
- Posts: 1248
- Joined: Mon Aug 03, 2009 9:37 am
- Location: North Mississippi
Re: Error message question
You never cease to amaze me acourtjester. Thanks for all you do.
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 7818
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: Error message question
Thanks you sir It's in my blood
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
- SeanP
- 4 Star Member
- Posts: 950
- Joined: Thu Aug 01, 2013 11:50 am
- Location: Co Kerry, Ireland
Re: Error message question
Don't know how we would manage without the internet! well done.
Powermax XP45
Home built table, Candcnc DTHC 2, Dragoncut 620-4
R-Tech 210 Tig, Jasic 250 mig
Sheetcam, Scanything, Coreldraw
Table build gallery
Home built table, Candcnc DTHC 2, Dragoncut 620-4
R-Tech 210 Tig, Jasic 250 mig
Sheetcam, Scanything, Coreldraw
Table build gallery