Ohmic Touch & Go Post Processor Question

SheetCam related questions and tips can be posted here
Post Reply
User avatar
The-Meerkat
1.5 Star Member
1.5 Star Member
Posts: 40
Joined: Thu Jun 27, 2019 8:28 pm
Location: North San Diego County

Ohmic Touch & Go Post Processor Question

Post by The-Meerkat »

Looking for the best post processor for a ohmic sensor touch & go setup used with SheetCam & Mach3. What post processor do use?
Scott Meer
User avatar
acourtjester
6 Star Elite Contributing Member
6 Star Elite Contributing Member
Posts: 8148
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: Ohmic Touch & Go Post Processor Question

Post by acourtjester »

here is a generic post I modified for use with a probe. you also need to enable the porbe input in Mach and select the pin you have the probe attached to for it to work. Some post that are set up for some electronics will need to be used due to their configuration. The main change from a floating head switch to probe is the change from G28 to G31 command in the post as shown in the attached image of the post I sent.
probe.JPG
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
User avatar
The-Meerkat
1.5 Star Member
1.5 Star Member
Posts: 40
Joined: Thu Jun 27, 2019 8:28 pm
Location: North San Diego County

Re: Ohmic Touch & Go Post Processor Question

Post by The-Meerkat »

Acourtjester, thanks so much. The weekend is here so I’ll load your post up tomorrow and give it a whirl.
Scott Meer
Post Reply

Return to “SheetCam”