Opinions on TruCut cnc?

Don't see your table manufacturer listed above? Post here in this forum.
Post Reply
Modernmetal
1 Star Member
1 Star Member
Posts: 11
Joined: Tue May 03, 2011 1:38 pm

Opinions on TruCut cnc?

Post by Modernmetal »

[o]
Last edited by Modernmetal on Thu Nov 15, 2018 9:28 am, edited 1 time in total.
jjellingson
1 Star Member
1 Star Member
Posts: 22
Joined: Mon Jun 06, 2011 7:52 am

Re: Opinions on TruCut cnc?

Post by jjellingson »

Can't say I am familiar with them, but did learn of a local builders site this week. Check out arclight plasma tables. Not sure where you are located but it may be some thing of interest to you. I was impressed with the site. I am sure if you had special requests on a table they may be helpful. good luck.
model a motel
1/2 Star Member
1/2 Star Member
Posts: 3
Joined: Thu Mar 15, 2012 4:48 pm

Re: Opinions on TruCut cnc?

Post by model a motel »

ive had my tru cut 4x8 in use for six months now and im completely satisfied they build a very well engineered table... they have been very helpful with any questions ive had as well.... they are number one in my book..
Modernmetal
1 Star Member
1 Star Member
Posts: 11
Joined: Tue May 03, 2011 1:38 pm

Re: Opinions on TruCut cnc?

Post by Modernmetal »

[o]
Post Reply

Return to “Various Manufacturers Forum”