Need this put into pieces to cut.
-
codonnell
- 1.5 Star Member
- Posts: 49
- Joined: Sat Jul 10, 2010 12:25 pm
Need this put into pieces to cut.
I'm an Ag teacher and looking to make single hole auto feeders for my kids pigs. Here are some measurements i have. Also heres a picture of one. 20.75" X 12.75" X 29.5". If someone could come up with this file so I can put it out and put it together without spend $80 each on them.
-
MQUICK
- 2.5 Star Elite Contributing Member
- Posts: 126
- Joined: Sat May 30, 2009 5:12 pm
- Location: Saint Louis, Missouri U.S.A.
Re: Need this put into pieces to cut.
I hope you have a brake to bend the metal. You will need to use hinges in place of the roll formed hinge that's in your pic. You have 2 sides, a back, a front, a bottom/front, a lower lid and a top lid. Some adjustments may be needed. I have never seen a pig feeder before so this is just from what I can get from your pic. You will have to delete the fold marks. I hope it helps.
You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here
