Jim, I just picked up an extra hand torch for my PM 65 so that I dont have to take my original off my table (Plasmacam) when I want to cut by hand. I was worried about this being a possibility, but I plugged new torch in and got everything hooked up and it wont fire. Being that the Plasmacam has the wire that hooks up to the back of the plasma cutter that controls when the torch on the table fires and cuts off, is this what is preventing the torch from firing? Im currently looking all through the PM 65 manual and Im going to go back and look at the Plasmacam video manual as well to see if I can figure it out, but figured Id post this to see if I get an answer before I can come to a conclusion. Thanks in advance.
Mark
Powermax 65 question for Jim Colt
-
- 3 Star Member
- Posts: 267
- Joined: Wed Nov 07, 2012 11:24 am
- Location: Virginia
Powermax 65 question for Jim Colt
PlasmaCam DHC2
Hypertherm Powermax 65
Millermatic 211 MIG Welder
Hypertherm Powermax 65
Millermatic 211 MIG Welder
-
- 3 Star Member
- Posts: 267
- Joined: Wed Nov 07, 2012 11:24 am
- Location: Virginia
Re: Powermax 65 question for Jim Colt
Welp figured it out. Forgot ALLLLL about the manual jumper. Its amazing what you can learn if you read the damn manuals.
PlasmaCam DHC2
Hypertherm Powermax 65
Millermatic 211 MIG Welder
Hypertherm Powermax 65
Millermatic 211 MIG Welder