Jim,
I purchased my PM65 and the Field Upgrade RS485 Board. the install is dirt simple and straight forward.
But I hooked it up to my CandCNC Blade Runner Ethercut RS485 Hub in the "Hypertherm" port and I don't see it in the Hub Admin is there any way to verify that it is functioning in the PM65? I don't know if the HUB is functioning properly...
Is there any indication that the thing is working?
Jim Colt RS485 Question
-
- 5 Star Elite Contributing Member
- Posts: 3087
- Joined: Mon Jul 20, 2009 11:18 pm
- Location: North Carolina
Re: Jim Colt RS485 Question
That is a better question to ask of CandCNC.com, they write the software code based on the Hypertherm protocol, maybe their software has some sort of self check for communication.
Jim Colt
Jim Colt