Keeping plasma dust off the Rails

Share and learn with other DIY members who have built their own plasma tables and accessories.
Post Reply
msimpson99
2.5 Star Member
2.5 Star Member
Posts: 210
Joined: Wed May 04, 2016 2:31 pm
Contact:

Keeping plasma dust off the Rails

Post by msimpson99 »

While my down draft works very well for my CNC Construction Set build, there is some sparks and dust that gets thrown off at 90 degrees.

The actual table sits just below the frame, some of the dust can still make it to the Y-rails. To solve this I added some guards to the build shown here:
_MG_6216.jpg
See my full write-up here:
https://www.kronosrobotics.com/cnccsdust2

You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here

Post Reply

Return to “DIY Plasma Table & Accessory Discussion Forum”