THC help with Mach3 controller

Share and learn with other DIY members who have built their own plasma tables and accessories.
Post Reply
Kruzzz
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Tue Nov 01, 2022 4:59 pm

THC help with Mach3 controller

Post by Kruzzz »

I am building my 1st plasma table and trying to wire torch heights controller to Mac 3 control board. I have found some wiring diagrams online but now I have no pins left for homing or emergency stop switch am I doing this wrong or do I need a different control board with more inputs. I believe I have heard of some people hooking torch heights controller directly tor directly to stepper motor drive but cannot find diagram on this my torch height controller is a CNC by PC model. Any help someone could give would be much appreciated everything else is done just stuck at this point.
weldguy
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1929
Joined: Fri Apr 17, 2009 11:48 am

Re: THC help with Mach3 controller

Post by weldguy »

If this is the THC you are referring to it does not look as though it will control a motor directly.

Post back with more info on the other components in your controller setup and maybe someone else here will be familiar and able to help.
THC.PNG

You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here

Kruzzz
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Tue Nov 01, 2022 4:59 pm

Re: THC help with Mach3 controller

Post by Kruzzz »

Yes thats it, I think I will get a new controler or smothstepper not sure of the differance any suggestions
Plasma-art
2.5 Star Member
2.5 Star Member
Posts: 166
Joined: Mon Sep 12, 2022 9:29 am

Re: THC help with Mach3 controller

Post by Plasma-art »

Ethernet Smoothstepper is a good option if you are lacking the I/O.
34by151
2.5 Star Member
2.5 Star Member
Posts: 157
Joined: Thu May 10, 2018 4:34 pm

Re: THC help with Mach3 controller

Post by 34by151 »

Mach3 is not great with an inbult THC.
The one you have still uses Mach3 for the THC3
Better to go for full standalone THC and offload the Z axis fully to the THC

For a standalone THC with stepper motor control of the Z axis , get the F1628D or AHA-L2
For DC motor control go for the XPTHC-4H

As you are considering a Smoothstepper I'd have a good think about Mach3
Your going to spend on a new controller and an THC

Far better to just get a mesa and go Linuxcnc. You will be far better off in the long run
Plasma-art
2.5 Star Member
2.5 Star Member
Posts: 166
Joined: Mon Sep 12, 2022 9:29 am

Re: THC help with Mach3 controller

Post by Plasma-art »

34by151 wrote: Thu Nov 03, 2022 3:16 am Far better to just get a mesa and go Linuxcnc. You will be far better off in the long run
I do agree on that if there are any mesa cards in stock or if you can get a used one.
That's the main reason I went with a second custom parallel BOB, not optimal but better then nothing.
Post Reply

Return to “DIY Plasma Table & Accessory Discussion Forum”