Cut chart for miller spectrum 2050?

Discussion forum for Lincoln & Miller plasma cutters
Post Reply
liftedon37s
1/2 Star Member
1/2 Star Member
Posts: 5
Joined: Wed May 07, 2014 12:42 am

Cut chart for miller spectrum 2050?

Post by liftedon37s »

I was wondering if anyone had the cut chart for a miller spectrum 2050 being used on a plasmacam 4x4 wigh dhc2. I currently have the settings to cut 16gauge at I believe .07 cutting height, 40 amps and 110-120ipm. I am getting a lot of dross that is not easy to clean up. I also wanted to say thanks for an awesome forum, it's sites like these that convinced me to get in to the cnc plasma cutting world. Any help would be greatly appreciated for a newbie.
jcoe1
1/2 Star Member
1/2 Star Member
Posts: 5
Joined: Sun Jul 28, 2013 10:42 am

Re: Cut chart for miller spectrum 2050?

Post by jcoe1 »

I'm still a newb my self but have you tried using 30 amp tips and slowing it down. Its my understanding you can get dross from running to fast and its harder to remove than dross from running to slow. I also have a 2050.
Dana gear
2 Star Member
2 Star Member
Posts: 54
Joined: Fri Jan 13, 2017 10:55 pm

Re: Cut chart for miller spectrum 2050?

Post by Dana gear »

Miller electric owners manuals, parts and service are all on line www.millerwelds.com
All tech is down loadable.
toschar
1/2 Star Member
1/2 Star Member
Posts: 5
Joined: Wed May 01, 2019 5:15 pm

Re: Cut chart for miller spectrum 2050?

Post by toschar »

thanks for telling where to get the manual for that this is the model I have to start with to!
Post Reply

Return to “Lincoln & Miller Plasma Cutters”