Help wiring a Miller 2050 to DTHC II or plasma table

Discussion forum for Lincoln & Miller plasma cutters
Post Reply
collinmaune
1/2 Star Member
1/2 Star Member
Posts: 3
Joined: Mon Mar 20, 2017 2:44 pm

Help wiring a Miller 2050 to DTHC II or plasma table

Post by collinmaune »

I need help wiring my miller 2050 to my CandCNC DTHC II
Dana gear
2 Star Member
2 Star Member
Posts: 54
Joined: Fri Jan 13, 2017 10:55 pm

Re: Help wiring a Miller 2050 to DTHC II or plasma table

Post by Dana gear »

The Miller 2050 is a good plasma power source , however I don't think it was ever shipped from Miller for CNC use.
The trigger circuit would be easy to do.
O.K. to move signal will most likely require a hall devise or reed switch sensing on the work cable this can be added into the machine itself.
Raw arc voltage, voltage feed back can be picked up easily within the machine.
You may want to contact http://www.millerwelds.com
The tech guys there can get you going on this.
Post Reply

Return to “Lincoln & Miller Plasma Cutters”