Spectrum 875 cut chart below 1/4"

Discussion forum for Lincoln & Miller plasma cutters
Post Reply
tex006
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Thu May 14, 2020 8:43 am

Spectrum 875 cut chart below 1/4"

Post by tex006 »

Just picked up my first table (not my first plasma cutter though by a long shot). Needing to set up kerf and cut speed for my Spectrum 875 with XT60 torch, 60A tip. Included manual only has 1/4"-7/8" cut chart and no mention of kerf size anywhere (I've got my program set up for .055" for now).

Anybody have one of these machines and willing to share a few settings? I'm looking to do some 16ga & 20ga. cuts for a small project.
Post Reply

Return to “Lincoln & Miller Plasma Cutters”