So, this is what I worked on this afternoon. The piece on the left is an aluminum small block chevy motor plate. The piece on the right is what I cut. The guy is going to mount an air pump to the engine and run it off the accessory drive. But he wanted it to mount to where the motor plate mounts. The extra material on top is where he will mount the air pump. Once he gets all that worked out, he is going to bring it back and have me cut the final piece out of aluminum. This one is 1/4" mild steel. Turned out pretty good for drawing it from scratch basically. Let me know what you think.
This afternoon's project
-
- 2.5 Star Member
- Posts: 194
- Joined: Sun Feb 26, 2012 1:42 pm
Re: This afternoon's project
looks good to me always nice when yo can do something start to finish and it comes out right
-
- 1 Star Member
- Posts: 19
- Joined: Wed Dec 12, 2018 11:37 pm
Re: This afternoon's project
any chance you have the file and would share? i need the water pump locations. thank you