Fire Bowl

[DARRYL21270]

Got the file for this a while back from another member and I finally cut it out. I used 3/16" steel

[Granite]

Very nice! I never saw this before. Is it just 5 flat pieces?

[GoingCustom]

Very nice! I never saw this before. Is it just 5 flat pieces?

yes, file is posted on the site here. Couple people have made it out of stainless. Cool design!

[DARRYL21270]

I like it a lot and have gotten many compliments. It's very heavy and I was initially worried about the thickness but then one of the salesman at the steel mill assured me it would be fine since people use 55 gallon drums as firepits and those aren't very thick at all.

[RobertJohnson]

Nice, I saw this on Plasmacams page.

[grindergary]

Very nice! I never saw this before. Is it just 5 flat pieces?

yes, file is posted on the site here. Couple people have made it out of stainless. Cool design!

Any chance someone still has the file available? I can't seem to find it on the site.

Thanks

Gary

[tnbndr]

File should be at this post.

http://www.plasmaspider.com/viewtopic.p ... pit#p41957

[grindergary]

Thanks tnbndr,
Funny it did not show up in a search before. or I'm losing my mind LOL

thanks again

Gary

[cstroke]

If you cut this from 1/4" open the slots a bit, I didnt... Grab a grinder and have a nice day moment... I for some reason never saw the "cut at 3/16" comment"
Reading comprehension is your friend...