Greetings to the Plasma Community!
Newbie from Indiana Rob here.
I need some help as I am in the process of learning our TruCut plasma machine from scratch.
I have ran into an issue. When I run any G-Code program developed in Sheet Cam, everything on the X-Axis runs consistently 60% greater than the target value. The G-Code line is correct in the program.
Anybody encountered this issue? If so, can you advise me?
Thanks,
Rob
New Member from Indiana - TruCut X Axis Issue - Help!
-
- 1/2 Star Member
- Posts: 1
- Joined: Fri Feb 07, 2020 9:38 am
-
- 3.5 Star Member
- Posts: 681
- Joined: Wed Nov 26, 2014 5:12 pm
Re: New Member from Indiana - TruCut X Axis Issue - Help!
I can't help but, I want to welcome you to the site