I went out to the shop to cut some stuff today and my torch won’t fire. I have a Hypertherm Powermax 65 with machine torch. I installed a new magnetic ground on it, but there’s no way that is the problem. I try to manually fire the torch in Mach 3 and the light comes on but nothing happens. I noticed when I take the consumables out there are no error messages on the plasma. Usually when I take the cap and nozzle off, there is an error light that comes on and you have to shut off and restart the machine. I did this today and no errors when I took the torch apart. Has anyone encountered this? Thanks guys.
Andy
Powermax 65 torch isn’t firing
-
- 1.5 Star Member
- Posts: 42
- Joined: Sun Jan 24, 2016 2:22 pm
- SegoMan DeSigns
- 4 Star Member
- Posts: 848
- Joined: Sat Jan 06, 2018 4:45 pm
Re: Powermax 65 torch isn’t firing
Jump pins 3 & 4 the torch should fire.
-
- 4 Star Elite Contributing Member
- Posts: 1968
- Joined: Fri Apr 17, 2009 11:48 am
Re: Powermax 65 torch isn’t firing
That is very odd. Try killing the power to the unit for a couple minuted then plugging it back in again and starting over.