Updated Hub Utility firmware and now the torch will not fire

For general topics and questions that do not fit into any of the other categories or forums.
Post Reply
Stanfeld
1/2 Star Member
1/2 Star Member
Posts: 3
Joined: Mon May 02, 2022 2:36 pm

Updated Hub Utility firmware and now the torch will not fire

Post by Stanfeld »

Updated the Hub Utility firmware from 1.6 to 1.8. Also updated the firmware for DTCH 5. Now the torch will not fire.

Is there more to the process when updating the Hub Utility?

Linux Mini Computer Command CNC 1.2.2
Bladerunner
Bulltear StarLab 5' x 10'
Hypertherm Powermax 85
BTA Plasma
3.5 Star Elite Contributing Member
3.5 Star Elite Contributing Member
Posts: 590
Joined: Thu May 12, 2011 4:28 pm

Re: Updated Hub Utility firmware and now the torch will not fire

Post by BTA Plasma »

First thing is to look at the pwm for a red light to come on. If it does not then press reset or cycle power on the hub. Also use the number on the gantry if you need more assistance.
Post Reply

Return to “CNC Plasma Cutters General Forum”