Feedrate

[odaydayday]

Can I change the feedrate without having to go back into sheetcam and change if I decide it’s too slow or too fast while cutting?

[Old Iron]

You haven't posted what software you're running.
Mach3 you click on edit Gcode then look for F code and change them all to whatever speed you want.

[odaydayday]

This is posted in the Mach3 section but thank you so much

[acourtjester]

YOu can move the green slider up and down on the fly, but changing the feed rate in the G-code is better, and it would be there the next time you cut that G-code.

feed.JPG (71.09 KiB) Viewed 747 times

[Old Iron]

This is posted in the Mach3 section but thank you so much

I wasn't paying attention