post processor not able to process

SheetCam related questions and tips can be posted here
Post Reply
Jason@bc
2.5 Star Elite Contributing Member
2.5 Star Elite Contributing Member
Posts: 209
Joined: Mon May 07, 2018 5:27 pm
Location: Moose Jaw Sask.

post processor not able to process

Post by Jason@bc »

I have just updated my processor to rev26 and for some reason when I put in peck pierce/drill marks it isn't able to post process it, just plain cutouts it

works fine, any help is welcome, thanks.




Here is a screenshot of the message error that pops up.
Attachments
sheetcam error.png
mjfabshack
1/2 Star Member
1/2 Star Member
Posts: 7
Joined: Tue Jul 16, 2019 2:06 pm

Re: post processor not able to process

Post by mjfabshack »

I know that this is a old posting but I have ran into this same error.
TJS
3.5 Star Elite Contributing Member
3.5 Star Elite Contributing Member
Posts: 707
Joined: Wed Nov 26, 2014 1:22 pm
Location: Fairfield, CT.
Contact:

Re: post processor not able to process

Post by TJS »

Go to the CandCNC forum. There is a thread about this. There is a new version of post 27e I think. I have been trying for a couple of days to get it to work. Again. I am new at this. Please post your screen shot of your tools for this in your sheet cam. I am doing something wrong even after the 27e post.

http://www.candcnc.net/supportforum/vie ... k&start=10
Post Reply

Return to “SheetCam”