horizontal lifting clamp

Haye · Post by **Haye** » Fri Jun 26, 2020 4:59 am

Hi folks,

I don't have my table yet however thinking about some small things to cut. Started drawing a horizontal sheet clamp to be cut out of 8mm material. Might be a good idea to alter the design a bit and cut two of the 'body' files to make it symmetric.

horizontal sheet clamp.dxf

Haye · Post by **Haye** » Fri Jun 26, 2020 5:32 am

something like this. 10mm spacing in between to accommodate 2 washers. Designed for a 16mm bolt to hold it together

Post by **adbuch** » Fri Jun 26, 2020 5:42 am

Nice!! What program are you using for the drawings? The first dxf opened, but I couldn't get the second one to open.
David

Post by **adbuch** » Fri Jun 26, 2020 5:44 am

lifting clamp image.jpg

Post by **plasmanewbie** » Fri Jun 26, 2020 9:49 am

Looks great and love the 3d renderings

Thank you

Haye · Post by **Haye** » Fri Jun 26, 2020 5:48 pm

adbuch wrote: ↑Fri Jun 26, 2020 5:42 am Nice!! What program are you using for the drawings? The first dxf opened, but I couldn't get the second one to open.
David

thats strange. This one is drawn in fusion360, exported as single dxf's per part, then combined in illustrator. Ill re-upload the second one again tomorrow.

Haye · Post by **Haye** » Sat Jun 27, 2020 6:37 am

Hereby the new file. Please not I haven't cut it myself, haven't cut anything at all

What tolerances do people use for the tab/slot system? I have drawn some lasercut parts, those almost always fit snug without any offset.

horizontal sheet clamp_v2.dxf

Post by **adbuch** » Sat Jun 27, 2020 8:17 am

Hi Haye,
V2 now opens fine.
Thanks,
David

version 2.jpg

Post by **cstroke** » Tue Jun 30, 2020 7:36 am

Thank you...

horizontal lifting clamp

horizontal lifting clamp

Re: horizontal lifting clamp

Re: horizontal lifting clamp

Re: horizontal lifting clamp

Re: horizontal lifting clamp

Re: horizontal lifting clamp

Re: horizontal lifting clamp

Re: horizontal lifting clamp

Re: horizontal lifting clamp