HT FlushCut consumables

Hypertherm Plasma Cutter discussion forum.
Post Reply
beefy
4.5 Star Member
4.5 Star Member
Posts: 1504
Joined: Fri Jan 18, 2013 3:19 am

Re: HT FlushCut consumables

Post by beefy »

Never heard of them so did a Google and had the info in a minute.

They are not for cutting a square edge, they are for presenting the plasma jet stream parallel to the top of the plate and as close as possible to the plate at the same time.

There's no "bending" of the arc stream, just the nozzle shape allows the jet stream to come out as just mentioned so that lugs, etc can be cut off the top of the metal as flush as possible.

Youtube videos come up in a Google search too.
2500 x 1500 water table
Powermax 1250 & Duramax torch (because of the new $$$$ync system, will buy Thermal Dynamics next)
LinuxCNC
Sheetcam
Alibre Design 3D solid modelling
Coreldraw 2019
robertspark
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 1805
Joined: Mon Jun 12, 2017 6:43 pm

Re: HT FlushCut consumables

Post by robertspark »

Post Reply

Return to “Hypertherm Plasma Cutters”