Hypertherm 105 height controller voltage
- ssderick
- 1.5 Star Member
- Posts: 27
- Joined: Thu Mar 04, 2010 10:34 am
- Location: Goliad, Texas
Hypertherm 105 height controller voltage
Upgraded from a thermal dynamics A120 in 2015 after frying boards in 4 of them, in as many years. Always ran this unit on 208 3 phase. Voltage for height controller was spot on with the chart in manual. Recently moved into my new shop. Hooked up to 480 3 phase. Now my voltage is about 60% lower than before. Cuts Fine. Just wondering why this is. Had to reconfigure all my voltage settings for all different plate thickness. We cut 3/8" to 3/4" all the time. One thing I can say, this unit cuts twice as fast, a lot cleaner, consumables are cheaper and last 10+ times longer than a thermal dynamics. Now I have replaced "3" TD 85 for Hypertherm 65 for hand cutting.
-
- 3 Star Member
- Posts: 357
- Joined: Tue Sep 30, 2008 3:40 pm
Re: Hypertherm 105 height controller voltage
That is strange, I have no idea why input voltage would affect it but I am sure someone here will. Curious to know what the answer is....
-
- 4.5 Star Elite Contributing Member
- Posts: 1816
- Joined: Mon Jun 12, 2017 6:43 pm
Re: Hypertherm 105 height controller voltage
could you take a photo + post it of the rating plate on the rear please?
- ssderick
- 1.5 Star Member
- Posts: 27
- Joined: Thu Mar 04, 2010 10:34 am
- Location: Goliad, Texas