Samson510 Table

PlasmaCam Hardware discussion forum
Post Reply
15gminder51
1/2 Star Member
1/2 Star Member
Posts: 1
Joined: Fri May 31, 2019 10:03 pm

Samson510 Table

Post by 15gminder51 »

In need of some help here... We just set up our new to us table. During the Initialize process the bar popped out of the rail. We can't find any obstruction or reason for it to do so... However the bar motor and hinges were all set up prior and we just slid it in the rails. I wouldn't be against taking it apart however I don't want to mess anything up by doing so. If anyone has any ideas or a way for me to get ahold of an instruction video it would be greatly appreciated. :)
User avatar
Joe Jones
5 Star Elite Contributing Member
5 Star Elite Contributing Member
Posts: 3041
Joined: Sat Oct 11, 2014 2:33 pm
Location: Franklin, KY., USA
Contact:

Re: Samson510 Table

Post by Joe Jones »

This is a late response but ... it popped out?!? That doesn't make any sense.

Where are you located?

Joe
Post Reply

Return to “PlasmaCam, Samson, & Go Torch Forum”