TM2- Howdo you incease the jog speed

Torchmate Hardware discussion forum
Post Reply
inspectweld
Posts: 31
Joined: Tue Dec 26, 2017 10:11 pm

TM2- Howdo you incease the jog speed

Post by inspectweld » Sat Oct 12, 2019 11:45 pm

I have the TM2 table and software and I would like to know how to increase the jog speed, thanks

weldguy
Elite Contributing Member
Elite Contributing Member
Posts: 367
Joined: Fri Apr 17, 2009 11:48 am

Re: TM2- Howdo you incease the jog speed

Post by weldguy » Tue Oct 15, 2019 11:56 am

I'm not a TM user but I suspect it will be in your post processor under rapid speed or similar term. Shouldn't be tough to locate and change. Good luck

User avatar
ben de lappe
Elite Contributing Member
Elite Contributing Member
Posts: 1043
Joined: Mon Aug 03, 2009 9:37 am
Location: North Mississippi

Re: TM2- Howdo you incease the jog speed

Post by ben de lappe » Tue Oct 15, 2019 2:32 pm

Prior TM 3 finished machine user with TM 4 driver software. No knowledge whatsoever of TM 2 but as the software is proprietary possibly in your driver software settings, see pic. Probably not as obvious as my Jog Speed button, total shot in the dark till someone with 2 experience chimes in. May also help to list your AVHC if applicable as well as driver for motors. Mine was model 401A signal generator.

You do not have access to view or download this file.
Become a Contributing Member to gain access to this feature. Click Here


modernpioneer
Posts: 1
Joined: Mon Mar 11, 2019 8:08 pm

Re: TM2- Howdo you incease the jog speed

Post by modernpioneer » Thu Oct 17, 2019 6:57 pm

Right here

You do not have access to view or download this file.
Become a Contributing Member to gain access to this feature. Click Here


Post Reply

Return to “Torchmate”

Easyscriber engrave attachment for Hypertherm plasma cutters.