Torchmate

Torchmate Hardware discussion forum
Post Reply
welder26
1/2 Star Member
1/2 Star Member
Posts: 1
Joined: Tue Apr 09, 2019 8:11 pm

Torchmate

Post by welder26 »

Hey there. I recently bought a cnc plasma at an auction.it has a torchmate driver and im wondering about different software that the drives will run
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1353
Joined: Tue Feb 28, 2012 6:47 pm

Re: Torchmate

Post by tcaudle »

if its an older model you need to look at the Flashcut control software for the Torchmate. If you did not get the control PC with the software then you only got part of a table. the early versions used an RS232 link from a Flashcut pulse card and later it was chagned to a USB card. The THC was not a Flashcut product and was only available from TM.
Post Reply

Return to “Torchmate Forum”