Blue screen AVHC OK to Move testing

Torchmate Hardware discussion forum
Post Reply
dn6835
1/2 Star Member
1/2 Star Member
Posts: 1
Joined: Wed Apr 14, 2021 11:49 am

Blue screen AVHC OK to Move testing

Post by dn6835 »

We have an older torchmate 4x4 with the "Blue Screen" AVHC I would like to test the "OK to move" switch since it doesn't seem to be getting that signal. Our unit follows the path correctly with the torch off and also takes right off if you shut off "OK to Move" in the AVHC and run a job. For testing, would I put an ohm meter on the "OK to Move" terminals on the AVHC or on the signal wire from the power supply to watch for a change in continuity? I don't just want to start hooking stuff up randomly. Thanks!
adbuch
6 Star Elite Contributing Member
6 Star Elite Contributing Member
Posts: 8599
Joined: Thu Sep 21, 2017 5:22 pm
Location: Tucson, Arizona
Contact:

Re: Blue screen AVHC OK to Move testing

Post by adbuch »

I would need to see the schematic wiring diagram in order to advise you as to the proper connections to test.
David
Post Reply

Return to “Torchmate Forum”