WinCNC THC with Hypertherm 65 Sync

Don't see your table manufacturer listed above? Post here in this forum.
Post Reply
ItsMePete
1/2 Star Member
1/2 Star Member
Posts: 2
Joined: Sat Feb 04, 2023 5:13 pm

WinCNC THC with Hypertherm 65 Sync

Post by ItsMePete »

I bought a pro star (shop Sabre) table and a new Hypertherm 65 sync. The old plasma, Hypertherm g3 1000. I took out the THC board out of the old plasma expecting to plug it directly into the new plasma board in the same way but did not find two pins to plug the board into.

The question- Can I use the internal voltage divider PCB on the Hypertherm, for my THC on win cnc? If so, does anyone know the conversion that WinCnc would use?

I did email winCnc, just hoping somebody has already done this process.

New here, awesome place and some great posts from everyone, hoping to learn and grow from what I find here.
tcaudle
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1353
Joined: Tue Feb 28, 2012 6:47 pm

Re: WinCNC THC with Hypertherm 65 Sync

Post by tcaudle »

Did you ever get an answer? Wincnc does not like dealing direct with users especially on old used tables. Its my understanding they had a custom board for their THC that was mounted inside the Plasma unit . That is probably where the two pin cable tied in. I don't think their THC card will work with the internal voltage divider...at least not that model. YOu migth try contacting Shop Saber who built and sold the table .
GooD luck
Post Reply

Return to “Various Manufacturers Forum”