jump start signal on a TD plasma cutter

Thermal Dynamics plasma cutter discussion forum.
Post Reply
HBGUERRERO
1/2 Star Member
1/2 Star Member
Posts: 6
Joined: Thu May 05, 2016 1:13 pm

jump start signal on a TD plasma cutter

Post by HBGUERRERO »

have some issues with my torch table. my plasma cutter just arcs/sparks continuously. trying to narrow it down. wanting to run the torch without using the computer/THC. Someone mentioned to jumper start signal on plasma cutter. Is there any instructions on how to do this? Have a TD A40 cutmaster
Post Reply

Return to “Thermal Dynamics / Esab Plasma Cutters”