Question

[ironhorse]

Anyone out there think this could be converted to a cutable dxf? It's a coat of arms.

Thanks in advance,

Greg

[tentonjj]

i played around with it and i cant help at all......sorry

[ironhorse]

Thanks for trying, yea I just can't see this being a dxf?

[SignTorch Vector Art]

technically, if you added .dxf on the end of the file name then saw'd your hard-drive in two that'd be a cuttable dxf file....

[Chopper John]

Hey Gary,

I was messin around with it also! I only had about ten minutes to put into it and didn't finish.

I like yours better!

[tentonjj]

OK........WTF am I doing wrong here?

[ironhorse]

Thanks guys, you amaze me! I had mo idea it could be worked into a cuttable file. Thank you for your valuable time,
Greg

[parrotlady]

OK........WTF am I doing wrong here?

I know right? These guys are incredible! Gary never ceases to amaze me! He has been tutoring me over in the software discussion forum, and the amount of knowledge he has simply boggles my mind.

[SignTorch Vector Art]

I was messin around with it also!

Hey Chopper John, you were off to a good start there... I like it.

I don't actually draw the whole thing at once like that, I like to zoom in on one section at a time and finish one part at a time. I didn't mirror both lions or both halves of the shields until the last minute.