DHC and GoTorch same controller?
- yeomansjon
- 3 Star Member
- Posts: 329
- Joined: Fri Oct 05, 2012 1:28 pm
- Contact:
DHC and GoTorch same controller?
Does anyone know if the Plasmacam DHC and GoTorch with Plasmacam controls uses the same controller box? My DHC control box died and until I raise a few bucks for the $7k upgrade, I wondered if a GoTorch control box would work in the interim.
Fast Jonny Custom Design
CNC Plasma Cutting
Plasmacam DHC
Hypertherm Powermax 1000
www.facebook.com/fastjonnycustomdesign
CNC Plasma Cutting
Plasmacam DHC
Hypertherm Powermax 1000
www.facebook.com/fastjonnycustomdesign
- rdj357
- 4 Star Elite Contributing Member
- Posts: 1186
- Joined: Sun Mar 11, 2012 4:40 pm
- Location: Tahlequah, OK
Re: DHC and GoTorch same controller?
Any new controller new or repaired by PC (from the last several years) will not work with the 3.11 or older software. The only option that I'm aware of other than the one you mentioned, would be to upgrade your software to Design Edge ($2k) and send your controller in for repair ($500-$700 I believe).
I'd recommend calling PlasmaCAM sales and discussing the options. Sorry that wasn't better news!
I'd recommend calling PlasmaCAM sales and discussing the options. Sorry that wasn't better news!
Robert Johnson
PlasmaCAM GURU & Instructor
I am not affiliated with PlasmaCAM, Inc. in any way. I offer training on their equipment and software. All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them are for nominative purposes only and does not imply any affiliation with or endorsement by them.
PlasmaCAM GURU & Instructor
I am not affiliated with PlasmaCAM, Inc. in any way. I offer training on their equipment and software. All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them are for nominative purposes only and does not imply any affiliation with or endorsement by them.