Hello

Post by **SRdesign** » Mon Nov 25, 2019 8:42 am

Hi all,

My work just recently purchased a 4x4 table to help with production and eliminate out-sourcing simple tasks. I have cnc router and 3d printing experience, and lots of Inkscape and fusion 360 experience so I have been tasked with being the lead man on the plasma table. I’ve been creeping around this site for a few months reading as much as I can. With all of the information available you can almost figure out anything that is wrong with your machine, or what you’re doing wrong to cause cut issues, without asking a question. Great forum with lots of wisdom available at your fingertips.

Post by **plasmanewbie** » Mon Nov 25, 2019 10:13 am

Welcome to the site! With your past experience this will easy for you. Good luck

Post by **SRdesign** » Mon Nov 25, 2019 11:55 am

plasmanewbie wrote: Mon Nov 25, 2019 10:13 am Welcome to the site! With your past experience this will easy for you. Good luck

Thank you!

Post by **robertspark** » Mon Nov 25, 2019 1:58 pm

Hello and welcome

Hello

Hello

Re: Hello

Re: Hello

Re: Hello