The torche stop

Chennasami · Post by **Chennasami** » Mon May 11, 2020 6:15 am

Hi
when i run a g code the machine works fine. But sometimes the same g code torch stops at the go.????, I try to go back to line G5 sometimes work . sometimes stop at G 00.
i want to understand where is problem .
Maybe air not dried??...
Plz help me

Post by **robertspark** » Mon May 11, 2020 9:33 am

Your problem I suspect is that your license is fake

https://www.machsupport.com/forum/index ... #msg241118

Artsoft kindly added some bugs to mach3 so that when you install it with a copied licence it does strange things so that it damages your work / cuts .... On the basis of it serves you right for using a fake licence

https://www.machsupport.com/forum/index ... #msg241118

I would suggest you switch to uccnc and buy a CNCdrive motion controller.... Or switch to Linux and run linuxcnc with plasmac... As it will be cheaper than buying a $175 USD mach3 licence for software that is no longer developed.... And essentially obsolete with many known bugs and nuances that uccnc and linuxcnc have resolved over time.

Chennasami · Post by **Chennasami** » Mon May 11, 2020 10:22 am

robertspark wrote: ↑Mon May 11, 2020 9:33 am Your problem I suspect is that your license is fake

https://www.machsupport.com/forum/index ... #msg241118

Artsoft kindly added some bugs to mach3 so that when you install it with a copied licence it does strange things so that it damages your work / cuts .... On the basis of it serves you right for using a fake licence

https://www.machsupport.com/forum/index ... #msg241118

I would suggest you switch to uccnc and buy a CNCdrive motion controller.... Or switch to Linux and run linuxcnc with plasmac... As it will be cheaper than buying a $175 USD mach3 licence for software that is no longer developed.... And essentially obsolete with many known bugs and nuances that uccnc and linuxcnc have resolved over time.

Thank you very much for the information . yes maybe the mach 3 license. please what is the version you recommend

Post by **acourtjester** » Mon May 11, 2020 1:04 pm

Ok there is another thing in play if you do not have a license you are limited to 250 (around that amount) lines of code. In you first image the line count is 274

Chennasami · Post by **Chennasami** » Mon May 11, 2020 2:35 pm

acourtjester wrote: ↑Mon May 11, 2020 1:04 pm Ok there is another thing in play if you do not have a license you are limited to 250 (around that amount) lines of code. In you first image the line count is 274

Thanks. I think the problem is about the license

The torche stop

The torche stop

Re: The torche stop

Re: The torche stop

Re: The torche stop

Re: The torche stop