New in Texas

[EverydayDiesel]

What did you wind up getting?

[adbuch]

He purchased this home built DIY table from a fellow plasmaspider member.
David

viewtopic.php?f=57&p=187233#p187233

4x4 table.JPG (87.54 KiB) Viewed 650 times

4x4 table.JPG (87.54 KiB) Viewed 650 times

[Birdiemc]

that's the one...works better than i had imagined, and the wife got to turn it in to a "vacation". what should have been drive 10hrs, load it up, then drive 10 hrs home turned in to left thursday around noon and got home sunday around 5pm...lol but happy wife happy life....

[Dfabltd]

Yea i have been thinking of building a 4x2mtr table for myself and going for a hy def hypertherm,
Ive seen nsk make the helical rack and linear rail all as 1 piece which would be very handy mount, been thinking of using aluminium extrusions to mount it on like swift cut use
have it mostly designed in sw might get to it over the winter

[BensPlasmaAu]

Candcnc sales about 500 of those units a year he is the only one complaining

Not the only one mate. At least he is honest about his experience and not shut down by bravado etc.

[dodom]

Quantify. Who else is complaining. He is not exactly honest.

[EverydayDiesel]

[adbuch]

I like it!
David