Eiffel Tower - First time upload

[herrmc@gmail.com]

My son wanted an Eiffel Tower wall hanging for his GirlFriend... this is what I came up with. Hopefully will cut it out tomorrow. I am uploading dxf, but it is drawn in Coreldraw.

[ironhorse]

Hey, that's a nice piece, good work.

[DXF]

My son wanted an Eiffel Tower wall hanging for his GirlFriend... this is what I came up with. Hopefully will cut it out tomorrow. I am uploading dxf, but it is drawn in Coreldraw.

Thanks for the file. I have been looking for an Eiffel Tower to use as a wall hanging. I haven't found one I like well enough to convert into a dxf file to cut. I think what I am going to do is take a picture of the one I posted here and convert it to a dxf cut file. I want it to look 3 dimensional.

Dave Hanks

[herrmc@gmail.com]

Ok, we found a peice of scrap 3/16" plate that barely accomodated... 9" at base, 26" tall. The plate was sitting outside, so it has a bit of surface rust... this first pic I will post is raw off the table.... we will spit and polish it up tonight or tomorrow. Will probably polish it to a shiny finish and clear coat... I have seen some of the work on here... and the discussions regarding "patina"... all new to me and looks really neat.

I know that this could be gussied up some more, just was looking to get something that looked good quickly for my son (not an artistic guru)....