New member intro

[Donny16]

Greetings to all!
My name is Donny and I'm trying to learn some of the ins and outs, ups and downs of the plasma table world. I have a wide variety of things id like to do as well as providing a learning environment for my son.

Thanks in advance for any tips and trickss
D-

[Donny16]

Would you guys by any chance recommend a good cutter? Budget is not great, around 500
http://weldzone.org/best-plasma-cutter-under-500/ any of those decent?

[acourtjester]

Welcome aboard Donny, you did not say if this is a hobby of workplace that you are looking for to use it in. First off the you need to have a blow back type ignition for the torch when using it on a CNC table, due to noise. I would say you should look at spending more than $500, over $1000 would be better. No multi purpose type as some on your list, and yes for a 220 volt unit. Best would be a Hypertherm but that is outside your budget, it is better to buy once and be happy, in place of cheap and need to replace again.