base plates flanges

dikko · Post by **dikko** » Sun Aug 14, 2011 4:41 am

does anyone have any base plates sq or round to share

JJsCustomDesigns · Post by **JJsCustomDesigns** » Sun Aug 14, 2011 2:21 pm

Not quite sure what your looking for. I have a nifty flange Macro if that helps.

Post by **azfabshop** » Sun Aug 14, 2011 8:58 pm

What exactly is that macro? Sounds useful!

JJsCustomDesigns · Post by **JJsCustomDesigns** » Mon Aug 15, 2011 10:44 am

Its called CADTool4. I picked it up at MacroMonster.com . It has alot of things that i havent even used yet. Flanges, cones, square cones... alot of shapes. You just put in your measurement and hit calculate and poof... you have a that shape.

Post by **azfabshop** » Tue Aug 16, 2011 11:39 pm

Cool! I'll check that out. Thanks!

Post by **azfabshop** » Tue Aug 16, 2011 11:44 pm

looks pretty cool and its only 25.00 too

dikko · Post by **dikko** » Sat Aug 20, 2011 2:27 am

thanks i will have a look i run a metal shop and im not good at drawing cad yet so was looking for a basic drawing of flanges and base plates for posts etc say 4 hole out of 6to 10mm steel approx 100mmx100mm to 200mmx200mm dikko

Post by **bogger44** » Mon Aug 22, 2011 9:01 pm

100x100 4 .5in holes

100x100.dxf

200x200 4 .5 in holes

200x200.dxf

base plates flanges

base plates flanges

Re: base plates flanges

Re: base plates flanges

Re: base plates flanges

Re: base plates flanges

Re: base plates flanges

Re: base plates flanges

Re: base plates flanges