Spine DXF

[TotalPerformance]

Another of my firsts. I scanned this, converted and cleaned up a bit. I'm good friends with my Chiropractor so I am making him a cool piece. I made the spine at 28ish inches out of stainless. I plan to space it off a background "plaque" and possible back light it, not sure yet. I hope it's of use to someone, just want to give back a little. Enjoy!

Spine.dxf

[plasmajoe]

Thank you, this file is cool.

Plasma Joe

[TotalPerformance]

Thanks Joe! I'm a big fan myself. I've cut quite a few of them. Not sure where they will all end up but it looks great. I've got a stainless one hanging on the wall behind my table. I wish stainless was a bit more affordable, I'd make everything out of it. Glad you enjoy it!

[azfabshop]

that sounds cool with the backlighting and all. You'll have to post a pic when you're done I'd love to see that!