New to the page!

[CadillacDan]

What's up guys I was recommended this page so far it looks really informative hopefully I can find answers to my question through others post rather then having to ask somthing that has been asked a million times. I have a 2x4 premier plasma table with a miller spectrum plasma cutter it does pretty good up to 3/16 by hand I have cut up to 1/2 but it took some time I'm looking to upgrade to a hypertherm 65 or 85 I dont want to be limited by thickness kind of buy once cry once. I have been playing with the table for about a year now and have pretty much learned how to run everything with the help of YouTube and just talking with people over Facebook now that I have found a actual fourm maybe that can help me progress faster I look forward to reading lots of post and learning!

[plasmanewbie]

Welcome aboard Dan. Sounds like your off to a good start and plenty of help here for sure. If you want a new Hypertherm your likely forced into the Sync system unless you are fortunate enough to find a previous generation of the 65 or 85 sitting in stick somewhere. Best of luck and post your questions if you cannot find the answer using the search feature here.

[adbuch]

Hi Dan. Welcome to the forum! It sounds like you are making plenty of good progress with your setup. What sorts of projects have you been doing, and what programs do you like to use for your cad/cam? Perhaps share a few photos of your setup and some of your projects.
Thanks,
David