Hey..!! Hello!! I bought a new plasma machine and I started using it a week already, ( LGK 120igbt) but I experiencing a problem when using it.
The machin will start working normally and suddenly stops for no reason. I don’t know if someone can help me please..!! Thanks and good day
-
-
Weekly Free DXF Design
-
Download DXF/SVG
cutting and suddenly stops problem
-
Katech
- 1/2 Star Member
- Posts: 1
- Joined: Wed Mar 29, 2023 10:47 am
-
weldguy
- 4.5 Star Elite Contributing Member
- Posts: 2359
- Joined: Fri Apr 17, 2009 11:48 am
Re: cutting and suddenly stops problem
Could be that your air supply cannot keep up and when the pressure gets too low the arc is extinguished.
Do you have a pressure gauge on the back of your plasma cutter where the air enters?
Do you have a pressure gauge on the back of your plasma cutter where the air enters?
-
acourtjester
- 6 Star Elite Contributing Member
- Posts: 8510
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: cutting and suddenly stops problem
More info on the suddenly stops, the plasma is only one part. If the controller stops that another story.
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
-
adbuch
- 6 Star Elite Contributing Member
- Posts: 11375
- Joined: Thu Sep 21, 2017 5:22 pm
- Location: Tucson, Arizona
- Contact:
Re: cutting and suddenly stops problem
Do you mean that the motion stops, or only the torch stops firing?Katech wrote: Wed Mar 29, 2023 9:52 pm Hey..!! Hello!! I bought a new plasma machine and I started using it a week already, ( LGK 120igbt) but I experiencing a problem when using it.
The machin will start working normally and suddenly stops for no reason. I don’t know if someone can help me please..!! Thanks and good day
David
