Hello Everyone
i got problems for my machine plasma cutting burny 10 lcd plus, and the status on LCD was "STOP--EXTERNAL STOP ACTIVE". and can you tell to me how to fix it?
Thanks
Problem EXTERNAL STOP ACTIVE on Burny 10 LCD Plus
-
- 1/2 Star Member
- Posts: 1
- Joined: Thu Jun 15, 2023 10:50 pm
- tnbndr
- 4.5 Star Elite Contributing Member
- Posts: 1678
- Joined: Mon Jan 09, 2012 4:30 pm
- Location: New Berlin, WI
- Contact:
Re: Problem EXTERNAL STOP ACTIVE on Burny 10 LCD Plus
Did somebody push that larger red button on top of the panel? To reset you need to turn it counterclockwise. You will hear it click back on.
If the button is not pushed then something in that circuit is bad, telling the machine that it has been activated.
Good Luck
If the button is not pushed then something in that circuit is bad, telling the machine that it has been activated.
Good Luck
Dennis
LDR 4x8, Scribe, DTHCIV
Hypertherm PM45, Macair Dryer
DeVilbiss Air America 6.5HP, 80Gal., 175psi, Two Stage
16.9scfm@100psi, 16.0scfm@175psi
Miller 215 MultiMatic
RW 390E Slip Roll (Powered)
AutoCAD, SheetCAM, Mach 3
http://ikescreations.com
LDR 4x8, Scribe, DTHCIV
Hypertherm PM45, Macair Dryer
DeVilbiss Air America 6.5HP, 80Gal., 175psi, Two Stage
16.9scfm@100psi, 16.0scfm@175psi
Miller 215 MultiMatic
RW 390E Slip Roll (Powered)
AutoCAD, SheetCAM, Mach 3
http://ikescreations.com
-
- 4 Star Elite Contributing Member
- Posts: 2033
- Joined: Fri Apr 17, 2009 11:48 am
Re: Problem EXTERNAL STOP ACTIVE on Burny 10 LCD Plus
I'm with Dennis and if the red button was pushed in and you turn it so it pops back out and you don't here anything or the error message does not go away there may be a Reset button on the screen that needs to be pushed and you may have to re-zero the XYZ axis' before you can begin cutting again.
- djreiswig
- 4.5 Star Elite Contributing Member
- Posts: 1958
- Joined: Thu Nov 19, 2015 10:02 pm
- Location: SE Nebraska
Re: Problem EXTERNAL STOP ACTIVE on Burny 10 LCD Plus
Is there possibly more than 1 estop button? Maybe on the opposite end of the table?
2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)
-
- 3.5 Star Member
- Posts: 558
- Joined: Thu Dec 05, 2019 11:33 am