New user Looking for plasma grates
-
- 1/2 Star Member
- Posts: 2
- Joined: Wed Sep 27, 2023 1:22 pm
New user Looking for plasma grates
I have an old plasma table that hasn't been used in a while because it needs new grates. I am here looking for grate files for a 5x10' plasma table.
- Joe Jones
- 5 Star Elite Contributing Member
- Posts: 3126
- Joined: Sat Oct 11, 2014 2:33 pm
- Location: Franklin, KY., USA
- Contact:
Re: New user Looking for plasma grates
What is the name of the table manufacturer? 5x10 grates can be made in many different configurations.
Joe
Joe
Franklin, KY., USA
Samson 510 & 4x4
6” Z Rail Lift Kit for PlasmaCam
CreatBot D600 PRO 3D Printer
12 Lasers
FREE DesignEdge Training!
It is more fun when it isn't necessary!
Samson 510 & 4x4
6” Z Rail Lift Kit for PlasmaCam
CreatBot D600 PRO 3D Printer
12 Lasers
FREE DesignEdge Training!
It is more fun when it isn't necessary!
-
- 1.5 Star Elite Contributing Member
- Posts: 57
- Joined: Thu Aug 06, 2020 3:17 pm
- Location: Wisconsin/ Minnesota
Re: New user Looking for plasma grates
hello, easiest option would be 1/8th flat stock at whatever height you need. if you need the holder for the slats, cut some slits in some flat stock an make a little frame to hold the slats. at least enough to get you up an running. good luck
- Joe Jones
- 5 Star Elite Contributing Member
- Posts: 3126
- Joined: Sat Oct 11, 2014 2:33 pm
- Location: Franklin, KY., USA
- Contact:
Re: New user Looking for plasma grates
I could be more helpful if I knew which make and model of table you have.
Joe
Joe
Franklin, KY., USA
Samson 510 & 4x4
6” Z Rail Lift Kit for PlasmaCam
CreatBot D600 PRO 3D Printer
12 Lasers
FREE DesignEdge Training!
It is more fun when it isn't necessary!
Samson 510 & 4x4
6” Z Rail Lift Kit for PlasmaCam
CreatBot D600 PRO 3D Printer
12 Lasers
FREE DesignEdge Training!
It is more fun when it isn't necessary!
-
- 1/2 Star Member
- Posts: 2
- Joined: Wed Sep 27, 2023 1:22 pm
Re: New user Looking for plasma grates
Sorry for the delayed response. I found the grates I was looking for in the shared dxf section of this site!